R-Vit iColor Flash

Rp 7.350.000

	Rp 7.350.000
	The R-VIT is an ultra modern tool that can display much needed information about the vehicles vital running data in real time. Warning limits can be set that flash when you have exceeded a pre-set limit, thus reducing the chances of expensive engine damage. The R-VIT connects to Japanese vehicles with an OBD II diagnostic port. These are mostly post 1996 vehicles. The R-VIT can display all the data from the vehicles ECU and its sensors on the inbuilt LCD screen. The R-VIT can read and display real time engine readings such as speed, tachometer, water temp, voltage, injector pulse, intake air temperature, air flow, inlet manifold temperature, oxygen reading, throttle position and many more. The data shown on the R-VIT is dependent upon the data read by the vehicles ECU and varies in different vehicles. R-VIT i-Color uses the same 65,000 Color LCD screen and multi angle display. as the SBC and MMD i Color boost controllers and are suited to Toyota CAN bus and Nissan systems.
The R-VIT i-Color is a monitoring multi meter designed for 2003 or later Toyota CAN-bus or japanese vehicles equipped with OBDII diagnostic connector 96 or later. The R-VIT i-Color uses the same 65,000 Color LCD screen and multi angle display. as the SBC and MMD i Color boost controllers. The display can be set to three different angles depending on the installation. Monitors a maximum of 29 items and able to display 6 monitored items simultaneously. Monitored items are: Speed, RPM, Water Temp, Ignition Timing, Fuel Injection Time, Air Flow Voltage, Outside Temp, Intake Manifold Pressure, Boost, O2 Voltage, O2 Rear Voltage, AF 1, AF 2, Intake Air Mass , Battery Voltage, Throttle Output, AT Temp, Gear Position, 4WD Ratio, Fuel Pressure, Momentarily Fuel Consumption, Error Diagnosis Code, Lock Up ON · OFF. External Voltage Input (Press, A/F Box) / External Temp Input, Fuel Pressure Control, Fuel Injection Control / Electric Fan Control, etc. Depending on the vehicle, the monitored items may vary or may not be monitored. The optional Pressure Sensor (or) the A/F Box must be separately purchased to display the external voltage input. The optional Temp Sensor must be separately purchased to display the External Temp Input. Press Sensor Set (19211) Temp Sensor Set (19210) A/F Box (15063) On active Control Function *CAN System Vehicles 2006+ Toyota/Lexus (except Hybrid) The Fuel Pressure, Fuel Injection and Electric Fan can be controller actively. There are some vehicles that this function cannot be used. The fuel pressure can be controlled every 100 RPM and can be increased of decreased from –9.9 to 25%. The fuel injection can be controlled every 500 RPM within the 3000 RPM range and can be increased of decreased up to ± 25%. The electric fan can be controlled to go ON or OFF within 20 to 100 degrees of the water temp. Data Record and Play /Graphical Display - a maximum of 10 minutes recording time. Graphically displays the AF 1/ AF 2 and the external voltage input based on RPM. (Useful for tuning) Only the external voltage input can be displayed if the AF 1/ AF 2 cannot be monitored. Note: Please contact us with vehicle details for further information on wether the R-VIT i-Color will work with your vehicle and for information on what can be displayed.